Out for an airing…
Click on image below: A Rovers return…….
First time in about 3 years….A slight hiccup due to leak in temporary fuel tank line, but quickly resolved. Sounded good… all six cylinders contributing nicely. Now to get it off the axle stands and drive up and down to turn round and start on the other sill. (garage not wide enough to work on both sides at the same time.)
Did I achieve the objective…..??
Well not quite.. The sill is pretty much complete…can’t do the final welding on the front section as I need to fabricate a replacement panel to replace the rust damaged area.
I did put the rear wheel on to get ready to lower the car back to the ground but as it started raining and as I had forgotten to recharge the battery…Plus I was hungry and tired….
I did turn the engine over a few times on the starting handle, and reconnected the temporary fuel tank….So it’s all set to go may be one night this week if the weather is fine!
Following months of inactivity I am planning to dedicate this weekend to the project.
The particular aim is to complete repairs to the off side sill.
The inner sill structure is almost complete, just some additional work to replace the internal running board webs, before final welding the outer sill in place.
Currently the car is on axle stands and can’t be lowered until the sill is complete for fear of distorting the body.
The ultimate goal of the weekend will be to get the wheels on and the car back down on the ground.
If all goes well I will fire up the engine and drive it out of the garage, turn it round, drive it back into the garage in preparation to start the near side sill.
Watch this space for progress and photos?
Here’s a short video of last time the Rover was started and running.